Fellowes Easy Glide Sit-Stand Work Platform Manual Del Usuario página 3

STEP 4
Attach the Rubber Bumper
• Attach the Rubber Bumper to the underside of the Keyboard
Platform using two M6 x 25mm Counter Bore Screws
STEP 5
Prepare the Lower Arm for Attachment
• Add one M6 x 10mm Counter Bore Screw to the back of
the Lower Arm
• Do not tighten the screw and be sure to leave 3/16"
(5mm) gap between the screw head and the plate
STEP 6
Attach the Lower Arm to the Dynamic Arm
• Hook the plate on the Dynamic Arm over the screw on the back of the Lower Arm
• Use two additional M6 x 10mm Counter Bore Screws and tighten all three screws
P
5 mm
HOOK
A
4
J
D
4-5 mm
P
5 mm
DO NOT TIGHTEN THE SCREWS!
L
L
4-5 mm
STEP 7
Attach VESA Plate
• Attach the VESA plate to your monitor using a Phillips
5 mm
Screwdriver and four M4 x 10mm Pan Head Phillips Screws
STEP 8
Attach Monitor
• Hook the monitor onto the top of the arm
• Secure the VESA plate to the Lower Arm using one
M6 x 8mm Counter Bore Screw
STEP 9
Adjust the Monitor Arm Tension
• Adjust the tension of the arm using a 8mm Torque Adjust Socket and Socket Wrench to match the weight of the monitor and accessories
• Turn clockwise for heavier weights and counterclockwise for lighter weights
6 mm
+90˚
N
F
P
5 mm
M
R
65˚
-30˚
8 mm
1/4" Drive
5