Set Up / Batteries - Healt o meter PROPLUS 1100KL Instrucciones De Uso

ASSEMBLY INSTRUCTIONS (CONTINUED)
Assembling an 1100KL Scale (continued):
9. Thread the 4 feet into the underside of the base. Each foot should be completely hand tightened and then
backed out 1-½ full turns. This allows for proper load cell operation for accuracy of the scale.
10. Carefully tilt the scale back to an upright position on the floor. DO NOT DROP THE SCALE. Adjust the
feet, to level the scale. Be certain that the feet are NOT completely tightened into the base (see Step 9).
11. Position the Display Assembly close to the Display Support. Plug the load cell cable connector into the
load cell port on the rear of the Display then insert and secure the cable into the center channel in the
display. See Figure 3, above, for an illustration. Note: Do not attach the power cord at this point. Wait
until Step 17.
12. Slide the display assembly onto the metal display support insuring that the two metal tabs go into the two
slots in the rear of the display. Note: The load cell cable should now be secured in the channel between
the display assembly and the display support.
13. Insert 4 Phillips pan head M4 screws (D) into the metal display support, and tighten.
14. Attach the Adapter Holder to the center rail using two (2) #8 x ½ sheet metal screws (C), and tighten.
15. Connect the power adapter to the power port in the display, then insert and secure the cable into the
exposed portion of the second channel from the left in the back of the display (see Figure 3, above). Hold
the cord in place through the retaining slot on the rear cover and align the large rear cover tabs with the
slots on the rear of the display assembly. Apply light pressure to snap the cover into place and secure it
with 2 Phillips pan head M4 screws
fully assembled.
16. Attach the rear and small front display support covers, applying light pressure to snap these covers
into place.
17. Secure the power cord to the inside of the center handrail, using the 4 plastic cable clips, arranged to hold
the cord out of the way. The adhesive backing on the clips will peel off then the clips can be fastened to
the scale by applying light pressure.
18. The scale is now assembled. Plug the scale adapter into a power source and / or insert batteries.
SET UP
ProPlus® 1100KL scales are shipped with the Menu Lock function enabled. The Menu Lock function
disables certain buttons on the scale's keypad, preventing unauthorized users from making changes to your
scale settings. The Menu Lock can be bypassed temporarily to allow you to customize your scale with the
functionality you prefer. Please refer to the ProPlus® Display Module User Manual for instructions on how to
bypass the Menu Lock.
Preparing the Scale for Use
1. Remove protective plastic films covering the keypad and display.
2. Place batteries in the battery holder (see "Batteries" information in Figure 4, below).
3. Plug the scale's power adapter into the power source.
4. Be sure all objects are removed from the scale's platform, and then press the ON/OFF button to turn the scale on.
The display will show "Health o meter ProPlus" and then "000Lb00oz" or "0.0KG". Note: To adjust the display
backlight and/or contrast, please refer to the ProPlus® Display Module User Manual.
Figure 3
Do not plug the scale into a power source until the scale is
(D).
- 5 -