Premier CR-4928R Manual De Instrucciones página 15

SELECTION OF FUNCTIONS
ON/OFF: Turns unit ON or OFF
•
• Press once to turn ON. Following indicator lights will illuminate: POWER, and SPEED. Unit
operates in default High fan speed. LED panel will display rotating fan at High speed.
• Press again to turn OFF.
• Swing: Horizontal swing of vertical louvers.
• Press once to engage auto swing of louvers. SWING indicator light will illuminate and LED
panel will display auto swing indicator.
• Press again for fixed air direction.
• To directing vertical airflow, adjust the horizontal louvers manually.
• Speed: Selects fan speed.
• Press to select desired fan speed: High – Medium – Low (for cooler), in turn. LED panel will
display the corresponding air speed.
• When the heating function are operating, the wind speed cannot be adjustable.
• Cool: For cool air / humidify function.
• Press once to start the evaporative cooling function. COOL indicator light will illuminate and
LED panel displays the cool indicator.
• Press again to stop function and operate in regular fan mode.
• Make sure water is added before turning on this function. Unit cycles the water to blow cool,
humidified air.
• Add ice to the water tank or use the supplied cold storage for added cooling.
• Timer: Sets timer-off in increment of 30 mins.
1. Timer can be set between 30mins to 8 hours.
2. TIMER indicator will illuminate and LED panel will display the set time.
3. To remove timer and operate unit continuously, press button repeatedly until indicator light
and display goes off.
• Heat:For heater function.
1. Press once to start heating function.Heat indicator light will illuminate and LED panel displays
the heat indicator of low hot 1000W.
2. Press again it operates in high hot 2000W.
3. Press third to stop function and operate in regular fan mode.
4. If the product operate under heat function, the cool , natural ,speed function can not be
used.
NOTE: Water must be added to the water tank before using the COOL function.
• Open the front door by the pulling gently on the handle.
• Add water to the tank. Do not overfill.
• For added cooling,add ice to the tank or place the icebox in the tank and put cold storage along
the track.Icebox and cold-storage must be placed in the freezer for at least 1 hour before
use.(Fig.1)
• Power supply should be disconnected before filling to prevent electrical parts from damage.
P-6
All manuals and user guides at all-guides.com