Human Touch Perfect Chair pc610 Manual De Uso Y Cuidado página 5

get ready
ATTACH THE HEAD PAD
1. Slide the head sock over the headrest frame.
Slide the head sock over the headrest frame, as far as it
will go. The padded side of the head sock should face
the back of the chair.
2. Slide the head pad over the headrest frame.
Slide the head pad over the headrest frame, ensuring that the
frame slides into the fabric pocket located on the bottom side of
the pad. Pull the head pad down as far as it will go.
3. Tuck in the body pad flap.
From the front of the chair, tuck the flap on the top of the body pad
up into the head pad and smooth it flat. The flap is automatically
secured to the pad, using the hook and loop fasteners.
4. Attach the head pillow.
Attach the head pillow straps to the head pad straps
using the hook and loop fasteners. Adjust the head
pillow height for maximum comfort.
humantouch.com
6
INSTALLING THE RECLINE CONTROLLER HOUSING
AND ARMREST CAPS
1. Remove the four screws taped to the top of the right-hand arm, then
place the arm core on top of the mounting plate. Secure the arm core
using the four screws and the Allen key (provided).
2. Remove the three screws that are taped to the underside of each armrest cap.
3. Note the shape of the top of the recline controller panel and
the matching shape of the recline controller housing.
4. Place the housing into position on the left-hand armrest as shown.
5. Make sure the matching shapes are tightly aligned to ensure
that the knob is center in the housing. IMPORTANT: If the knob
is not centered you will not be able to operate the chair properly.
6. While holding the housing firmly in place, place the arm cap into
position and press down firmly.
7. Check again to make sure the recline controller knob is centered inside
the housing, then replace the three screws to secure the armrest cap.
8. Use the remaining three screws to install the right-hand armrest cap.
Arm core
Recline controller housing
Recline controller panel
Recline controller housing
Arm cap
7