Whalen WMFP48FH-10-KD Manual Del Usuario página 24

R
F
Knob
(2 used in this step)
28. Attach one Knob (10) to the front side of each Door (R) with the Knob Bolt (11).
29. Pick up one Door (R) and attach the extended Hinge Arms to the Hinge Bases installed on the Side Panel
(F). Loosen the bolt on the back of Hinge Base for an easy fit. Align and insert the "U" slot on Hinge Arm
under the bolt head on the back of Hinge Base. Make sure that both door hinges engage and function
properly. Tighten the bolt on the Hinge Base to lock the hinges in place.
30. Repeat the same procedure to attach the other Door (R) to the Right Lower Side Panel (G).
31. Open and close the doors to make sure they are aligned and shut correctly. If necessary, adjust the screws
for a good fit. Refer to the hinge sticker on door for adjustment.
32. Stick the Rubber Bumpers (12) at the outer corners of the Doors (R) where they come in contact with the
Lower Partition Panels (H and I).
Assembly Instructions
11
10
R
12
⑩
11
R
10
G
R
12
Knob Bolt
(2 used in this step)
⑪
24
1
Rubber Bumper
(4 used in this step)
⑫