BOND MANUFACTURING HYFP40205-65 Manual Del Usuario página 7

ASSEMBLY INSTRUCTIONS
* Please keep these owner's manual for future reference.
*If you have opened the carton and removed all packages, please disregard the STEP 1 . See the
STEP 2 directly.
STEP 1-A. (1) Open the carton and turn it upside down, make
sure the 4 pieces of the cartons open up as below in Figure
STEP1-A.
(2) Lift off the carton carefully and be wary of the accessories
inside falling away.
(3) Take all the packing materials away except for the pa-
per honeycomb board rounding the top of the firebowl.
STEP 2.
(I) Check each part before using the product. Make sure the gas
supply system is turned "OFF" before assembling. See Figure C.
(II) Open the storing door on the firebowl for the gas tank.
(III) Put the gas tank in the metal stand. Make sure the gas
tank sits on the metal stand completely. Turn the wing screw
on the outer part of metal stand clockwise to secure the gas
tank tightly. See Figure F.
V
(I ) Locate the battery and remove the plastic cover first.
Unscrew the rubber cap of the Electric Ignitor, place the AAA
battery into the battery case. Make sure the positive pole ("+")
towards the cap. Screw the cap back to the battery case tightly.
See Figure D.
(V)
Evently distribute the lava rocks on the top of the fire-
bowl. See Figure E.
** DO NOT COVER THE IGNITION SCREEN
when placing the lava rocks into the firebowl. Al-
ways keep Ignition Screen visible.
** Connect the Pressure-Regulating Valve to the gas
tank. See Figure G.
1) Turn the cylinder valve clockwise to close the gas
supply on the gas tank.
2) Screw Regulator coupling clockwise by hand only.
Make sure it is fastened.
STEP 1-B. (1) Turn the firebowl heads up on a flat
ground.
(2) Remove all the paper honeycomb board rounding the
top of the firebowl.
7
G