Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Step 3.
Middle and bottom slide chutes have tongue-and-groove joint on the edge for connection
◆
purpose.
◆ Lay out the middle slide chute (L) and bottom slide chute (M) on the side as figure shown.
Connect the middle slide chute (L) and bottom slide chute (M) by embedding tongue-and-groove
◆
joint firmly, ensure the connection are perfect , so that the two chutes meet closely
and there is no gap between the chutes.
Only thread the upper screw hole of middle and bottom slide chute with the hardware
◆
(bolt Ex1 + washer Fx1 + spring washer Gx1 + domenut Hx1).
◆ Leave the lower screw hole of middle and bottom slide chute unassembled.
Step 4.
◆ Top Slide chute (K) with rounded-edge.
Top and middle slide chutes have tongue-and-groove joint on the edge for connection
◆
purpose.
◆ Lay out the top slide chute (K) and middle slide chute (L) on the side as figure shown.
Connect the top slide chute (K) and middle slide chute (L) by embedding tongue-and-groove
◆
joint firmly, ensure the connection are perfect , so that the two chutes meet closely
and there is no gap between the chutes.
Upper
L
K
K
Rounded-edge
M
L
L
E (M6x15) 2x
F (M6)
2x
G(M6)
2x
H(M6)
2x
M
M
Publicidad
Tabla de contenido
