Alcad 912-UC Guía Rápida De Programación página 2

QUICK PROGRAMMING GUIDE 912-UC
Start/on
Main menu
Select series Transcodifi cador 912 QPSK - COFDM
NIT Table
Select series
912-UC IF processor
912-MS Modulators
912-UC IF processor
Confi gure module
Set the programming switch of the 912-UC module to the ON position. The programming
Processor 1
Input frequency
950
Output frequency
950
A.F.C.
Off
Bandwidth
27
Processor 2
Input frequency
950
Output frequency
950
A.F.C.
Off
Bandwidth
27
Set the programming switch of the 912-UC module to the OFF position. The programming
OK
OK
OK
indicator will now light up and remain lit.
MHz Keypad + T
MHz Keypad + T
OK+
OK+
MHz
MHz Keypad + T
MHz Keypad + T
OK+
OK+
MHz
indicator light will now go out.
Press the Power On key of the PS-011 to start up the
system.
Choose Select Series to select the programming series.
Select the series: 912-UC IF processor.
To commence programming the module, select Confi gure
module.
Use the numeric keypad to enter the IF frequency of the
input transponder. Then press T to transmit.
Use the numeric keypad to enter the IF frequency of the
output transponder. Then press T to transmit.
Select on/off for Automatic Frequency Control (A.F.C.).
+OK+T
Then press T to transmit.
Select the bandwidth of the transponder, 15, 27 or 36
+OK+T
MHz. Then press T to transmit.
The same as processor 1.
The same as processor 1.
The same as processor 1.
+OK+T
The same as processor 1.
+OK+T
ENG