Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
for the location of the mounting screws on the wall. Mount
the charger securely using drywall screws (purchased
separately) at least 1" (25.4 mm) long, with a screw head
diameter of 0.28–0.35" (7–9 mm), screwed into wood to an
optimal depth leaving approximately 7/32" (5.5 mm) of the
screw exposed. Align the slots on the back of the charger
with the exposed screws and fully engage them in the slots.
Intended Use
This screwdriver is designed for professional
screwdriving applications.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
This screwdriver is a professional power tool. DO nOT let
children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Quick-Release Chuck (Fig. A, B)
nOTE: The chuck accepts 1/4" (6.35 mm) hex accessories
and 1" (25.4 mm) bit tips only.
Place the forward/reverse button
(center) position and remove battery pack before
changing accessories.
To install an accessory, fully insert the accessory into the
quick-release chuck
6
. The accessory is locked into place
(Fig. B).
To remove an accessory, pull the chuck collar
from the front of the tool. Remove the accessory from the
quick-release chuck
6
(Fig. B).
Fig. B
6
7
Mode Selection (Fig. A)
The mode selection collar
5
and the max position.The collar should be rotated until the
desired setting is located at the top of the tool.
WARNING: When the mode selection collar is in the
Max position, the drill will not clutch. The drill may
stall if overloaded, causing a sudden twist.
symbol
MAX
1–15
Screwdriving (higher number = greater torque)
8
in the lock-off
4
away
7
is clearly marked with numbers
Mode
Drilling
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. C)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
1
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
2
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual
Fig. C
2
Proper Hand Position (Fig. D)
WARNING:To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle
12
and one hand on the battery pack. Hold tool
firmly with both hands to control the twisting action of
the screwdriver.
into the tool handle, align the
1
Publicidad
Tabla de contenido
