Kenwood KTC-V301E Manual De Instrucciones página 7

4.
Rub a rubber spatula against the
transparent sheet to affix the
antenna element to the windshield
tightly. If the rubber spatula is
not available, use a small board
wrapped with cloth.
5.
Slowly peel off the transparent
sheet along the element line.
6.
Make sure that the antenna element
has been affixed tightly, and then
affix the cable connector to the
element terminal.
7.
Route the cable and secure it
with the supplied cable clamps
(Accessory 5).
Rubbing directions and places
Inside the
vehicle
Outside the vehicle
Peel-off direction
Inside the
vehicle
Outside the vehicle
Element terminal
Peel-off direction
Antenna element
Windshield
Antenna element
Windshield
Cable connector
(Accessory 3 and 4)
Affix the cable connector
in such a manner that
the bare portions of the
antenna element are
aligned with the line
shape protrusions of the
cable connector.
7
|
English