Brandson Equipment 303030 Manual Del Usaurio página 53

11 Height adjustment mechanism
12 Pedestal cover
13 Pedestal weight
14 Washer
15 Pedestal - locking screw
16 Tilt adjustment
17 Carriage bolt
18 Locking screw
19 Mounting screw
20 Outer pipe
21 Locking screw + safety nut
5. Installation
Take the fan out of the package and check the device as well as the scope of deliv-
ery mentioned in the table above. Please contact the vendor if any part is missing
or has been damaged. Now place the rear protective cage (5) on the fan unit. Make
sure that the handle is facing up.
Tighten the rear protective cage firmly using the mounting screw (4).
Then insert the rotor blade (3) onto the rotor axis (6) and fasten it using the ap-
propriate mounting screw (2). In doing so, ensure that the screw sits on the notch
of the shaft of the motor axis in order to guarantee a firm grip!
Mount the front protective cage (1) onto the rear protective cage. A hole is pro-
vided for a locking screw at the bottom of the two protective cages.
Insert the locking screw (21) through the hole of the front and rear guards and fas-
ten it using the locking nut. Then connect the four mounting brackets to the side.
Please screw the mounting screw (19) to the outer pipe first to connect the inner
pipe (10) with the motor unit. Then, you can mount the remaining screws (16,
17, 18).
Take the pedestal weight (13), place the guard (12) on it and connect the outer
pipe (20) to the pedestal.
English
53