Machine Set-Up - Clarke American Sanders 3DS Manual Del Operador

ENGLISH
EN
Machine Setup
Listed below are the tools needed for setup of the
machine: 1 - #2 Phillips screwdriver
2 - ½" open end wrenches or (2) adjustable
wrenches.
To prepare the machine for use, follow this procedure:
1. Remove all components of the machine from its pack-
age and check for damaged or missing parts.
2. Read Operation and Parts Manual, including all dan-
ger, warning, and caution st atements before operat-
ing the machine. If you or the operator are unable to
read the language this manual is printed in, have the
manual fully explained before attempting to operate
this machine.
3. Attach the sanding unit to the truck frame by secur-
ing the two hand knobs through the truck frame to
the sanding unit. (see Figure 6). The eccentrics in
the truck frame should be used for proper alignment
between the truck frame and sanding unit. Match tick
marks on spacers and frame; one on right and two
on left.
4. Route the motor power cable under the head pres-
sure strap and vacuum support strap, then over the
tilt assist strap.
5. Secure the handle assembly to the truck frame by
bolting it on with the four 5/16-18 bolts and nyloc
nuts supplied and plug in motor power cord. (see
Figure 7) Tighten the nuts that hold on the tilt wheels
and attach the vacuum support straps as per figure
7.
6. Put Dacron filter around the cloth filter . (See Figure
8)
7. Set the dry vacuum on the vacuum support straps
with the center bottom in the 2" diameter hole. NOTE:
The vacuum hose port should be facing the sanding
unit motor. Attach the vacuum strap around the base
of the vacuum. (See Figure 9)
8. An optional disposable paper bag is available. If you
wish to use the paper bag, remove the vacuum head
and install a paper dust control bag by inserting the
deflector on the vacuum into the mounting shoe of
the paper bag. To ensure the bag is properly seated
on the deflector , the rubber seal should rest in the
groove of the deflector (See Figure 10). NOTE: Check
the paper bag for proper seating after transport to
avoid dust in the vacuum tank.
9. Wrap the vacuum cord around the cleats located on
the back of the handle. Leave enough slack in the
cord to plug into the electric box. Turn the vacuum
switch to the "ON" position. The vacuum switch should
remain in the "ON" position. (See Figure 1 1 below)
Figure 11
-8-
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
American Sanders Operator's Manual (EN) - 3DS
®
Clarke