Recharging The Powerpette Pro; Fitting The Powerpette Pro Wall Bracket; Specification - VWR Powerpette Pro Manual De Instrucciones

Recharging the Powerpette Pro

Before starting to operate, carefully check mains voltage and
recharge batteries. To charge the Powerpette Pro:
‒ Plug the charger jack (6) into the base of the Powerpette Pro.
‒ Plug the charger (5) into a suitable wall socket. The LED
indicator within the Powerpette will flash green.
‒ Place the Powerpette Pro onto bench stand, the unit will take
16 hours to fully charge.

Fitting the Powerpette Pro wall bracket

The Powerpette Pro bench stand is supplied ready to use as a
wall bracket. When used as a bench stand it is recommended
that the wall fitting is removed.

Specification

Technical Data
Batteries 2 x 1.2V nickel
metal hydride
Battery service Life 500–1000 cycles
from empty
Charger 75mA/h for 16
hours plug-in;
Overall weight 180 g without stand
Filter (8)
Hydrophobic 25 mm
dia 0.45 µm (fitted)
plus two additional
spare filters
Manifold material ABS
Case material ASA
Nosecone material
ASA (10)
Pipette holder Silicone (9)
Pipette types Plastic or glass
1–100 ml
Installation Double insulation
(over voltage) indicated on
category II charger by symbol
1x 0.45 µm 1x 0.20 µm
‒ Once the Powerpette Pro is fully charged, the charger
automatically switches to a trickle charge operation and
during this period the LED indicator will remain constant
green. If the charge to the Powerpette Pro is interrupted and
then re-started the charger will begin its 16 hour cycle and
will switch to a trickle charge operation as above. This will
not damage the battery.
‒ Only use the charger indoors and protect against moisture.
‒ Recharging temperature +10 °C to +35 °C.
Bench stand
Wall bracket
POWERPETTE PRO
Wall fitting
Instruction manual | vwr.com 5