Getting Started (Installation) - Marmitek DOORGUARD 100 Modo De Empleo

4. Getting started (installation)

Description of the parts
Figure 1 Doorbell camera, front
1. Screw hole
2. Speaker (for the visitor to hear your voice)
3. Camera (for you to see who's at the door)
4. Button doorbell
5. Microphone
6. Screw hole
Figure 2 Doorbell camera, back
1. Screw hole
2. Cable to transfer picture and sound to the monitor
Figure 3 Monitor, front
1. Receiver
2. Screen
3. Operation LED
4. Intercom LED
5. Door open LED
6. Monitor button
7. Intercom button
(to communicate between different
monitors, if applicable)
8. Door open button
9. On the side: sliders/wheels to set
volume, brightness and contrast
Figure 4 Monitor, back
1. Power cable
2. Connectors for camera cable
3. On-Off switch (used in case of multiple monitors)
4. 75 Ohm switch
Step 1 Mounting the doorbell camera to the frame
• Drill a hole (15 mm) through the frame, at the height you want to mount the
doorbell camera.
• First push the wall bracket, then the sun hood and lastly the camera together. Do not
forget to feed the camera cable through the hole in the wall bracket as well.
• Feed the cable through the hole in the frame and mount the doorbell camera on the
frame with the screw included.
4
Figure 1
Figure 3
Figure 2
Figure 4
© MARMITEK