Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Guidance and manufacturer's declaration – Electromagnetic Emissions
(as request by regulation EN 60601-1-2:2001)
The Breast-Pump NEW MAMILAT is intended for use in the electromagnetic environment specified below.
The customers or the user of the Breast-Pump NEW MAMILAT should assure that it's used in such an
Emissions Test
Irradiated / Conducted emissions
CISPR11
Irradiated / Conducted emissions
CISPR11
Harmonic emissions
IEC/EN 61000-3-2
Voltage fluctuations /
flicker emissions
IEC/EN 61000-3-3
Guidance and manufacturer's declaration – Electromagnetic Emissions
(as request by regulation EN 60601-1-2:2001)
The Breast-Pump NEW MAMILAT is intended for use in the electromagnetic environment specified below.
The customers or the user of the Breast-Pump NEW MAMILAT should assure that it's used in such an
Immunity Test
Electrostatic discharge (ESD)
IEC/EN 61000-4-2
Electrical fast transient / burst
IEC/EN 61000-4-4
Surge
IEC/EN 61000-4-5
Loss of voltage, brief voltage
interruptions and variations
IEC/EN 61000-4-11
Magnetic field
IEC/EN 61000-4-8
Conducted Immunity
IEC/EN 61000-4-6
Irradiated Conducted
IEC/EN 61000-4-3
Note U
is the value of the power supply voltage
T
environment.
Compliance
Group 1
Class [B]
Class [A]
Complies
environment.
Compliance
± 6kV on contact
± 8kV in air
± 2kV power supply
± 1kV differential mode
5%U
for 0.5 cycle
T
40%U
for 05 cycle
T
70%U
for 25 cycle
T
<5%U
T
for 5 sec
3A/m
3Vrms 150kHz to 80MHz
(for appliances that aren't life -
supporting)
3V/m 80MHz to 2.5 GHz
(for appliances that aren't life -
equipment)
10
Electromagnetic environment -
guidance
The Breast-Pump NEW MAMILAT only
used RF energy only for its internal
functioning.
Therefore its RF emissions are very low
and are not cause interference in
proximity of any Electronic appliances.
The Breast-Pump NEW MAMILAT can
be used in all environments, including
domestic and those connected directly
to the public mains distribution that
supplies power to environments used
for domestic scopes.
Electromagnetic environments -
guidance
Floors should be wood, conceret or
ceramic tile. If floors are coverei with
synthetic material, the relative
humidity should be at least 30%.
Mains power quality should be that of a
typical commercial environment or
hospital
Mains power quality should be that of a
typical commercial environment or
hospital
Mains power quality should be that of a
typical commercial environment or
hospital If the user of Breast-Pump
NEW MAMILAT request that the
appliance operates continuosly, the
use of a continuity unit is
recommended.
The power frequency magnetic field
should be measured in the intended
installation location to assure that it's
sufficiently low.
-
-
Publicidad
Tabla de contenido
