Dmx Linking - Colorist POD 18Qa Guía De Referencia Rápida

Colorist Pod 18Qa QRG

DMX Linking

DMX Connection
IP65 DMX Cable
Table
IP65 DMX
Connector Pins
RDM
(Remote Device
Management)
The Colorist Pod 18Qa will work with a DMX controller using a regular
DMX serial connection.
www.iluminarc.com.
The Colorist Pod 18Qa uses a regular DMX data connection for its DMX
personalities: 4-CH, 6-CH, and 10CH. See the User Manual to connect
and configure for DMX operation.
Connection
Ground
Data -
Data +
Male IP65 (DMX Input)
To connnect the Colorist Pod 18Qa to your DMX network, it is
necessary to use the 3-pin to 5-pin adapters supplied with this
product.
When not using the Power Output, DMX Input or DMX Output
connectors, you must seal the cable ends with the supplied caps.
Remote Device Management, or RDM, is a standard for allowing DMX-
enabled devices to communicate bi-directionally along existing DMX
cabling. Check the DMX controller's User Manual or with the
manufacturer as not all DMX controllers have this capability. The
Colorist Pod 18Qa supports RDM protocol that allows feedback to make
changes to some menu map options. Download the User Manual from
www.chauvetprofessional.com
A DMX
DMX (U.S.) DMX (Europe)
Shield
White
Red
F
emale IP65 (DMX Output)
for more details.
4
Primer is available
IP65 Pin
Shield
Blue
Brown
EN
from
1
2
3