Error Messages And Error Clearance; Technical Data | Safety Information | Care And Maintenance | Warranty - WellerFT Zero Smog 2 Traducción Del Manual Original

Care and maintenance
Warning!
Before doing any work on
the machine, pull the plug
out of the socket.
Use original replacement
parts only.
Contaminated filters must be
treated as special waste.
Dispose of replaced equip-
ment parts, filters or old
devices in accordance with
the rules and regulations
applicable in your country.

Error messages and error clearance

Message/symptom
Extraction power missing
„
Zero Smog is not running
„
Sub-micron paricle
„
becoming dirty to quickly
Warranty
Claims by the buyer for physical defects are time-barred after a period of one year from delivery to the
buyer. This does not apply to claims by the buyer for indemnification in accordance with §§ 478, 479
BGB (German Federal Law Gazette).
We shall only be liable for claims arising from a warranty furnished by us if the quality or durability warranty
has been furnished by use in writing and using the term „Warranty".
The warranty shall be void if damage is due to improper use and if the device has been tampered with by
unauthorised persons.
Subject to technical alterations and amendments.
For more information please visit www.weller-tools.com
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
To ensure that the filtration system functions properly, the filter must
be replaced as follows
at least once a year or
„
if the maximum allowable workplace concentration is exceeded or
„
as per maintenance schedule
„
The suspended matter filter and the broadband gas filter are comple-
mentary to one another and can be replaced together as a compact
filter. The compact filter must be changed once a year in order to
ensure it is fully functional. The fine dust filter (filter mat) is the pre-
liminary stage of the compact filter and therefore must be replaced
more frequently.
Notice
Different fluxes and flux constituents and the amount of and size
of dust particles in the extracted air will signifi cantly effect the fil-
ters working life. Submicron particles in the extracted air increase
when soldering or welding to varnish insulated wire.
Possible cause
Pipe system leaking
„
Filter is dirty
„
Thermally switched off
„
Pre-filter has not been used
„
Remedial measures
Reseal the pipe system
„
change the filter
„
Leave the Zero Smog to cool
„
down Switch on again afterap-
prox. 3 hours
Use a pre-filter Fit an F7 filter
„
Use a preliminary seperator if the
proportion of solid matter is high.
13