For Charger Acg218W2U - Hyper Tough HT19-401-003-05 Manual Del Operador

Charging the battery pack
NOTE:
•The batteries are shipped uncharged. Each battery must be fully charged before the
first use.
• Always fully charge the two batteries at same time.
WARNING! The charger and battery pack are specially designed to work
together, so do not attempt to use any other devices. Never insert or
allow metallic objects into your charger or battery pack connections because
of an electrical failure and hazard will occur.
Installing & Removing the battery pack
NOTE:
This machine will only run when 2 batteries are installed. It is recommended to
use the same two batteries and charge the two batteries at the same time.
When you use two batteries with different power, the machine will only run to
the lower common denominator.
OPERATION
Starting & Stopping
WARNING!
The tool runs for a few seconds after it has been switched off. Let the motor
come to a complete standstill before setting the tool down.
Blowing
USER TIPS
- Hold the blow tube approximately 8" above the ground when operating the tool.
- Use a sweeping motion from side to side. Advance slowly keeping the accumulated debris/
leaves in front of you.
- After blowing the debris/leaves into a pile, it is easy to dispose of the pile.
Caution!
- Do not blow hard objects such as nails, bolts, or rocks.
- Do not operate the blower near bystanders or pets.
- Use extra care when cleaning debris from stairs or other tight areas.
- Wear safety goggles or other suitable eye protection, long pants, and shoes.

For charger ACG218W2U

IMPORTANT NOTES FOR CHARGING BATTERY
The battery in your new tool is not charged when it leaves the plant. Therefore it must be full charged before using the first
time.
NOTE:
If the battery pack is very hot you must remove your battery pack from the charger and allow your battery pack to cool
first to ambient temperature and then recharging can be started.
To prevent damage to the Battery Pack, when charge runs out, please charge the battery to reach full or no less than half
charge before storage.
If the tool will not be used for long periods of time, charge the battery every 3-6 months.
CHARGING PROCEDURE (SEE FIG. C1)
1) Plug the charger into an appropriate outlet. The light will be green.
2) Slide the battery pack into the charger, the light will turn to red to indicate the charging process has started.
3) When charging is completed, the light will turn to green. The pack is now fully charged, unplug the charger
and remove the battery pack.
WARNING:
When battery charge runs out after continuously use or exposure to direct sunlight or heat,
allow time for the tool to cool down before re-charging to achieve the full charge.
9
See Fig. C1, C2, C3
See Fig. D
See Fig. E
See Fig. F