Rating Plate; Operation And Handing; Opening Cans - CASO DESIGN D10 Manual De Instrucciones

14.2 Rating plate

The rating plate with the connection and performance data can be founded beneath the
device.

15 Operation and Handing

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
Warning
► Do not leave the device unsupervised when it is in operation, so that you can intervene
quickly in the event of dangers.

15.1 Opening cans:

Caso D10
Plug the electrical cord into an outlet.
Bring the magnetic lid lifter into the horizontal position as shown in
Figure 1.
Then please lift the can opener lever to a 45° position until it locks.
Place the can so that the rear edge of the can lip rests on the drive
wheel.
Be certain that the cutting blade is on the inside of the can lip
as shown in figure 2.
Push the can opener lever down firmly and hold until the can lid is
automatically pierced and the cutting action begins as shown in
figure 3.
Please note
► It is not necessary to hold the can opener lever down during the
cutting cycle.
When the can is fully open, the cutting action will automatically stop.
The can will remain in position until the lever is raised.
To release, grasp the can firmly in one hand and raise the lever using
the other hand. The magnetic lid lifter will retain the lid as shown in
figure 4.
Warning
► Don't touch the cutting edge of the can, since this is very sharp.
► Remove the lid carefully from the magnet and dispose of it.
32