THOMSON RCD210U/BT Instrucciones De Funcionamiento página 16

GENERAL OPERATION
1. Select your sound source by pressing the FUNCTION button.
2. Increase the volume by rotating the VOL +/– knob clockwise and decrease the volume by rotating
the VOL +/– knob anticlockwise.
3. To switch off the device, press the POWER button.
RADIO OPERATION
For better reception
• Pull out the antenna and extend to its highest position.
1. Switch on the device by pressing the POWER button.
2. Press the FUNCTION button repeatedly to select the "FM" function.
How to use the radio buttons
a. Manual Tuning
- Higher frequencies can be selected by rotating the "TUN +/–" knob clockwise.
- Lower frequencies can be selected by rotating the "TUN +/–" knob anticlockwise.
b. Automatic Tuning
- Rotate and hold the "TUN +/–" knob until the display frequency starts to run.
- When a station of sufficient strength has been found, tuning will stop or you can stop automatic
tuning by rotating the "TUN +/–" knob again.
- Repeat until you have found the desired station.
3. Adjust the volume by rotating the VOL +/– knob.
PRESET TUNING
1. Tune to your desired station using the normal tuning procedure.
2. Press the PROG button then use the REP/M– or RAN/M+ button to allocate a number to the
station (NO. 1 to NO. 20).
3. Store the current frequency by pressing the PROG button again when you reach the desired
number.
4. Repeat the same procedure to set other desired frequencies for memory no. 1 to no. 20.
Note: a stored frequency can only be deleted by storing another frequency in its place.
The device can be preset for up to 20 stations.
MEMORY RECALL
Recall the stored frequencies by pressing the REP/M– or RAN/M+ button to select stations 1 to 20 as
desired.
CD/MP3 DISC OPERATION
PLAYING A CD/MP3
1. Open the CD door by pressing it.
2. Insert a CD with the label facing up.
3. Close the CD door.
4. Switch on the device by pressing the POWER button and press the FUNCTION button repeatedly
to select the "CD" function.
5. The CD's first track will play automatically.
6. Press the PLAY/PAUSE button to pause.
7. To stop the track, press the STOP button.
USING THE USB
First, insert your USB key into the USB input.
1. Switch on the device by pressing the POWER button.
2. Press the FUNCTION button repeatedly to select the "USB" function.
3. The USB will automatically play the first track.
4. Press the PLAY/PAUSE button to pause.
5. To stop the track, press the STOP button.
- EN 5 -