Initial Setup - Crosley CR6038A Manual De Instrucciones

English
25. RCA Jacks
26. Spring Clip Speaker Terminals
27. External Antenna

Initial Setup

Essential Setup
1. Place the unit on a flat and level surface. The selected location should be
stable and free from vibration.
2. Remove the tie-wrap that is holding the tonearm.
3. Rotate the Turntable Suspension Screw clockwise until it is all the way
down. This allows the turntable to float on its shock absorbers.
4. Place the slip mat on top of the turntable platter.
5. Connect AC adaptor to the Power Jack of the unit.
Note: Do not plug the AC power adaptor to power outlet before all the assembly is
completed. Before turning the power on, make sure again all the connection settings
are correct. Always turn off the power when connecting or disconnecting.
Stereo System Connection
RCA Jacks
 The RCA Jacks output analog line-level signals and could be connected
directly with a pair of active/powered speakers or the appropriate input of your
stereo system.
 The Red plug connects with the Right channel and the White plug connects
with the Left channel.
Note: The RCA Jacks are not designed to be connected directly to the passive/unpowered
speakers. If connected to the passive speakers, the volume level will be very low.
28. Power Jack
29. 45 RPM Adapter
5