Truper DES-1000 Manual Del Usuario página 19

Mounting
Guard
• Install the guard as shown in the image.
• Remember to correctly install the guard before turning ON the trimmer.
1
Use care not to touch the
blade's sharp edge that
cuts the cutting line.
Cutting line spool
• Having the trimmer OFF and disconnected, remove the
spool retention cap (F) turning in a counterclockwise
direction.
• Remove the empty spool. Make sure is clean and there
are no damaged or worn parts.
• Cut a 10 ft length of line.
• Bend the line to the middle of the length and insert in
the notch.
• Hold both lines and thread in the direction indicated in
the arrow on the spool. Double check each length of line
is threaded in the respective section. (upper and lower).
Do not thread too much line. After threading, there must
be a 0,24" minimum distance between the spool edge and
the threaded line.
• Leave unthreaded 6" approximately of both lengths of
line and insert the upper section line in one of the notches
in the spool cover. Give half a turn more to the spool and
insert the line in the lower section in the opposite notch of
the spool cover.
This measure is to prevent the line to get unthreaded
while installing the spool in the trimmer. Further on, the
threads shall be released from the notches.
• Set back the spool in its cover (H) passing each line ends
through the orifices in the cover. If the line is released or
tangled in this step, thread it again in the spool and secure
in its notches.
• Pull outwards and apply force to both ends of the cutting
line to release it from the notches in the upper side of the
spool.
• Set the spool with its cover into the impulsion axis (I)
and push the spool towards the axis to make the threaded
edge stick out. Secure it with the retention cap (F).
• When setting a new spool, release the tips of the lines
from the notches and unthread 6" approximately of both
lines to secure them back in their notches before setting the
spool into the cover.
• We recommend using 0,062" diameter, model
HDU-15-65, HTA-65, HTA-65B, HIDE-65P cutting lines.
2
G
Cover
Orifice (x2)
Notch Release
Notch
I
H
F
7
ENGLISH