Thompson MIC250IBT Instrucciones De Funcionamiento página 21

4. "Alarm 1 (or 2) Setup" is displayed. Press the ENTER button to select.
5. "Alarm 1 (or 2) Wizard On time" is displayed and the hour digits for the alarm will flash.
6. Press /
7. Press /
8. Press /
9. Press /
10. Press the /
minutes. Press the ENTER button to select. Press
save the alarm.
11. The display will show the current time and Alarm 1 (or Alarm 2).
Snooze
1. Whenever the alarm (alarm 1, alarm 2) comes on, it can be temporarily suspended for a short
period of approximately 9 minutes, by pressing the "SNOOZE" button once.
2. The alarm (alarm 1, alarm 2) will then automatically come on again after the 9-minute "snooze"
period has ended.
3. And the "snooze" symbol will show on the display to remind you that the snooze function is active.
4. To deactivate the snooze, press and release the "POWER" key once.
Sleep Timer
1. Repeatedly press the SLEEP button; you can set 90/80/70/60/50/40/30/20/10 minutes. This is
useful for falling asleep to music at night.
2. If you want to cancel the sleep mode, repeatedly press SLEEP to select OFF; the sleep mode will
cancel.
FM Radio
Carefully extend the telescopic aerial to its full length. You can program a maximum of 30 preset radio
stations (FM)
Auto Scan
1. Rotate the SOURCE key to select "RADIO" mode.
2. Long press the
station of sufficient signal strength (30 stations preset).
3. After a few seconds, the display will update. The display will show the station frequency.
4. Press MEM to view the preset radio stations
5. Press MEM+ or MEM- to view or listen to the stored radio stations.
6. To find other stations, press and hold the
7. To scan the FM band in the opposite direction (high frequencies to low frequencies), press the
button and hold for 2 seconds.
Manual Scan
1. Rotate the SOURCE key on the main unit to select "RADIO'' mode.
2. Press or
frequency up or down by 100 kHz.
3. Once you find a station you want to save, press the MEM button on the remote control. "P01"
will be shown on the display; press MEM+/MEM-until the desired memory position number
appears on the display. Press the MEM again to confirm and save the current station.
4. Press MEM+ or MEM- to view or listen to the stored radio station.
(Note: When the waveband end is reached, the radio will recommence tuning from the opposite
waveband end. If no stations are found, please ensure the aerial is extended and test the reception by
doing another auto scan in a different location.)
repeatedly to set the hour. Press ENTER to confirm.
to set the minutes. Press ENTER to confirm.
to select the Alarm volume from 0 to 30. Press ENTER to confirm.
to scroll to OFF/CD/DAB/FM/USB/BUZZER status. Press ENTER to confirm.
button to scroll to the alarm duration. You can choose from 15, 30, 45 and 60
button, and your radio will scan and stop automatically when it finds a
to tune to a station. Each press on the tuning button will change the
/ to select YES and press ENTER to
button as before.
- EN 7 -