Before The First Use - Tristar ST-8915 Manual De Usuario

Instruction manual

BeFoRe THe FIRST uSe

• Before the first use, please remove any sticker or protective cover.
• Place your steam generator on a stable, horizontal heat-resistant
surface.
• For the first use, use the iron on an old piece of fabric to ensure the
soleplate and water tank are completely clean.
• Never use the steam generator when water tank is empty, refill it
before use it again.
NoTe: It is normal that strange odor comes out from the unit for the first
use. This will cause after a short while.
NoTe: Some particles may come out of the soleplate when you use the
iron for the first time. This is normal; the particles are harmless and stop
coming out of the iron after a short while.
NoTe: When you switch on the appliance, the steam generator may
produce a pumping sound. This is normal; the sound tells you that water is
pumped into the steam generator.
NoTe: During the heating process of the soleplate, there will be little
steam coming out from the soleplate automatically, this phenomenon will
continue for about 3 seconds, This is normal.
uSe
Dry ironing
1. Put the iron on the steam generator's base.
2. Connect the plug to wall outlet and press the power button.
3. Turn temperature dial to your desired setting, which is depended on
the fabric of garment. The temperature indicator will illuminate, the
iron starts heating.
6
4. When the temperature indicator turns off, the selected temperature is
reached, you can start ironing.
caution: Never touch hot soleplate at any time!
Steam ironing
1. Unlock the water tank with the trigger and pull out the water tank,
open the filling cap and fill it with water. Use of purified water with less
calcium particles will extend the life time of the appliance. The max
capacity of water tank is 1.7L, never exceed the maximum water level.
2. Replace the detachable water tank properly.
3. Put the iron on the steam generator's base.
4. Connect the plug to the wall outlet, press the power button, the
defaulted low steam rate indicator will flash. Turn temperature dial to
your desired setting, which is depended on the fabric of garment, the
temperature indicator will illuminate.
5. The water in the tank will be heated, after a few minutes, the
temperature indicator will be extinguished, it indicates the soleplate
reached the selected temperature. After a few minutes the selected
steam rate indicator will illuminate constantly, now the appliance can
produce steam.
6. According to your requirement, you can select the desired steam
output, there are three modes: low, medium and high. Make sure that
there is enough water in the tank.
caution: Never direct the steam at people!
7. After ironing, press the power button for a while and the appliance will
be turned off, all the indicators will be extinguished. Remove the plug
from the wall socket. The soleplate is still hot make sure you'll never
touch it, place the iron on the thermal insulating cushion to let it cool
down completely.