AXIS T91A Series Installation Guide
Install the AXIS T91A62 Parapet Mount
Hardware overview,
1. Refer to
parts.
2. Route the network cable through or along the roof.
3. Attach the bracket holder in the desired position on the roof using
screws that are appropriate for the material and the weight of the
camera and bracket. Install the bracket maximum 80 mm
the edge of the roof for the camera's outer diameter to be aligned with
the edge of the roof. Maximum weight allowed 15 kg (33 lbs).
4. Route the necessary cables through the parapet bracket, securing them
in the cable holder.
www.a1securitycameras.com email: sales@a1securitycameras.com
on page 4 for information on the supplied
Note: Do not use bracket holder
Install bracket holder
max. 80 mm (3.2 in.)
from the edge of the roof
from
(3.2 in.)
as a temporary support
with the parapet bracket.
Cable holder
Cable
Bracket holder
Page 7