Cleaning And Maintenance - cecotec FAST&FURIOUS 4010 VITAL Manual De Instrucciones

ENGLISH
pop out.
Loosen the lid by turning it anticlockwise and open it.
Pull the piston rod to the top and pour pure water into the tank until the tank is full.
Then, tighten the water tank lid clockwise, and push the water tank into the main body until it
is safely fixed.
Plug the power cord into a power outlet.
Fig. 4.
The device will start heating up and the light indicator will turn on red. Once the device is fully
heated, the light indicator will turn blue.
Note: Before filling the water tank, the piston rod must be slowly pulled out to the bottom of
the water tank until it stops.
Fig. 2.
Hang the clothes to be ironed on a hanger. Clothes can also be placed on an ironing table to
be steamed in a horizontal position.
Press the steam button to start steaming and press it again to stop the steam flow.
Hold the steam iron and keep it in a vertical position while avoiding the steam iron from
pointing at people or animals.
Fig. 6.
Move the garment steamer up and down, right and left.
When you have finished using the device, unplug the power cord.
Insulation pad assembly and disassembly
Fig. 5.
Hold the floor insulation pad with one hand, hold the product with the other hand, insert the
front end of the garment steamer head into the floor insulation pad, and then assemble the
end of the floor insulation pad into the steamer head. Use extreme precaution to avoid burns.
Fig. 6.
To remove it, hold the iron firmly, pull the bottom part of the floor insulation pad away and
take it completely out.
Tips
Always test garments by steaming a small hidden area to make sure the garment operates
properly and is ready to use.
Always wait until the light indicator turns blue before starting steaming.
Always read garment care label instructions before ironing or steaming clothes and other
garments.
Do not press the garment steamer against the same area for a long time when ironing, so as
not to damage the clothes.
Small amounts of dripping might occur during use. If excessive, the garment steamer may
34 FAST&FURIOUS 4010 VITAL
need time to get back up to full temperature. Allow the garment steamer to reheat.
Wearing clothes immediately after ironing or steaming can actually create wrinkles. Always
allow clothing to cool for about 5 minutes after ironing or steaming before wearing it.

4. CLEANING AND MAINTENANCE

After use, unplug the appliance from the power supply, empty the water tanks (do it after each
use) and allow it to cool down completely.
Use a damp, soft cloth to clean the appliance's surface after each use.
Do not use abrasive scouring pads, powders or cleaners to clean the product.
If the appliance is not going to be used for a long time, pour out the water in the tank and store
it in a safe, cool place.
Always store the garment steamer in an upright position on its base to prevent water leakage.
Wind the power cord properly.
Always make sure the device has completely cooled down before storing it.
ENGLISH
FAST&FURIOUS 4010 VITAL 35