Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1
1) Control Panel Cover
2) Fire Adjustable Switch
3) Thermostat
4) Switches
e.
a. Fan (without heating)
b. Heat 900W
c. Heat 900W
d. Fire
Operating Instructions
Insert Plug Into Socket
Functions
Remove the control panel cover(1)
Select the desired function:
-
Fire (4d)
-
Fan (4a) (without heating)
3
4a
4b 4c 4d
-
Half power 900w (4a + 4b)
-
Full power 1800w (4a + 4b + 4c)
-
Heat and Fire (4a + 4b + 4c + 4d)
Fan function is necessary to activate heat functions.
Without fan the heating can not run.
Adjust light of fire by rotating the fire adjustable switch (2)
clockwise until desired intensity.
To adjust the permanent temperature:
-
Turn the thermostat (3) clockwise to the biggest
point.
-
When the room temperature goes up to be
comfortable then turn the switch (3) in an
anticlockwise to break point and keep the button
2
position.
-
The function can keep necessary room temperature
and also save energy.
Light exchange (see following picture)
Loosen the three screws at the front of log .
Lift up the log decoration. Two bulbs are located under fuel
bed.
Replace the bulbs with a 25W type
To reassemble, follow previous instructions in reverse
order.
Publicidad
Tabla de contenido
