Bimar VP455T Folleto De Instrucciones página 14

 Ensure that the fan is switched off from the supply mains
before removing the guard.
INSTALLATION
 After removing the packing materials, check the integrity of the appliance; if you
are unsure, do not use it and ask for qualified professional help. The packing
materials (plastic bags, polystyrene foam, nails, etc.) must be kept out the reach
of children because they are potential sources of danger. Attention: any stickers
or advertising material applied to the grid removed before using the appliance.
The manufacturer declines all responsibility in case this is not safe working
practices will be respected.
 Before connecting the appliance, check that the voltage values shown on the
data plate correspond to those of the electricity supply network. In the event of
incompatibility between the electric outlet and the plug of the appliance, have
the outlet replaced with another more suitable type by professionally qualified
personnel, who will make sure that the section of the wires of the outlet is
appropriate for the absorbed power of the heater. In general, the use of adapters
or extension cords is not recommended; if their use is indispensable, they must
conform to existing safety standards and their current capacity (amperes) must
not be less that the maximum of the appliance.
 The power socket must be easy to reach so the plug can be removed quickly in
case of emergency.
 To not place the appliance near sinks or other container of liquids (minimum
distance of 2 meters) to avoid the risk of it falling in.
 Do not place the appliance near an open flame, cooking or other heating
appliance.
 Keep the fan far away from fabrics (curtains, etc.) or unstable materials that
could obstruct the air intake grille; make sure that the front is free of unstable
materials (dust, etc.).
 Make sure that the electric cord is not touching rough, hot or moving surfaces
and not twisted or wrapped around the appliance.
 Stand the appliance on a horizontal, flat surface or table; do not stand on a
inclined plane (the appliance could upset).
ASSEMBLY
Before assembling the fan, make sure it is unplugged from the socket.
The appliance can only be used once correctly assembled in all its parts, complete
with counterweight base, protective grills, propeller.
Proceed as shown and use the images for reference.
A. Unscrew and remove the ring nut (6) from the column, insert the ring (3), and
tighten the ring nut again.
B. Set the column (14) in place on the base and secure it using the "L" screw with
washer (1) while also engaging the counterweight.
C. Make sure column and base and counterweight are firmly coupled.
14