Tabla de contenido
Publicidad
Caster spacers also can be repositioned to change
cutting heights and to change the pitch of the deck. (See
Figure 6)
Figure 6. Caster Wheel Spacers
BLADE HEIGHT ADJUSTMENT
Adjusting the blade height can be done by moving any
number of the five smaller 1/4" spacers on the blade
mounting bolts to the top of the spindle shaft or below
the spindle shaft.
-NOTE-
All blades should be positioned equally.
For best cut and discharge, a minimum of three spacers
should be installed between the blade and the spindle.
(See Figure 7)
CUTTER BLADES
Do not sharpen beyond 1/3 of the width of the blade.
(See Figure 8)
-NOTE-
Dress the blade with a file. Using a wheel
grinder may burn the blade. Check the balance
of the blade. If blades are out of balance, vibra-
tion and premature wear of spindle assembly can
occur. See your authorized Scag dealer for
blade balancing or special tools if you choose to
balance your own blades.
Pin
Spacers
2003SGB005
WARNING:
Always wear proper hand and eye protection
when working with cutter blades.
Figure 7. Blade Spacers
Do Not Cut In
30
Figure 8. Blade Sharpening
9
2002 SWSPCRS
Angle Blade Back
X Must NOT Exceed
1/3 Blade Width
SGB033
Publicidad
Tabla de contenido
