Troubleshooting - TRENDnet TDM-E400 Guía De Instalación Rápida

Troubleshooting

Q1: POWER LED does not illuminate after the product is turned on. What should I do?
A1:
Verify that you are using the power cable provided with the device and that it is securely
connected to the ADSL2+ modem and a wall socket/power strip.
Q2: I am not sure what type of Internet broadband connection I have for my DSL
connection. How do I find out?
A2:
You can contact your Internet Service Provider's (ISP) Customer Service or Technical
Support Department for the correct information.
Q3: I specified the IP address 192.168.1.254 in my Web browser, but an error messages
says, "The page cannot be displayed. How can I get into the TDM-E400 / TDM-C400 web
configuration page?
A3:
Please check your hardware and TCP/IP settings again by following the instructions in
the QIG. Make sure the Power, WAN and the LAN LEDs are on. Then try to access the
configuration page using your Web Browser again.
Q4: INTERNET LED does not illuminate after phone cable is attached.
A4:
Verify that a standard telephone cable (called an RJ‑ 11 cable) like the one provided is
securely connected to the ADSL port and your wall phone jack. Allow about 30 seconds for
the device to negotiate a connection with your ISP.
Verify that you are using a straight-through type Ethernet cable to the uplink port on a hub or
a cross-over type cable to a stand-alone PC. If you connected the device to an ordinary hub
port (not Uplink), you must use a straight-through cable. (To check: hold the connectors at
each end of the cable side-by-side with the plastic spring facing down. Looking at the wires
from left to right, if the first, second, third, and sixth wires are the same color on the two
connectors, then it is a straight-through type. On a cross-over type, wire 1 on one connector
should be the same color as wire 3 on the other. The same is true of wires 2 and 6.)
Q5: Ethernet LED does not illuminate after Ethernet cable is attached.
A5:
Verify that the Ethernet cable is securely connected to your LAN hub or PC and to the
ADSL2+ mdoem. Make sure the PC and/or hub is turned on.
Verify that your cable is sufficient for your network requirements. A 100 Mbps network
(10BaseTx) should use cables labeled CAT 5. A 10Mbps network may tolerate lower quality
cables.
Q6. My LAN PCs cannot display web pages on the Internet.
A6:
Verify that the DNS server IP address specified on the PCs is correct for your ISP, as
discussed in the item above. If you specified that the DNS server be assigned dynamically
from a server, then verify with your ISP that the address configured on the ADSL2+ modem is
correct, then you can use the ping utility, described on page 174 of the user guide,
to test connectivity with your ISP's DNS server.
11