Oil Change And Filter Cleaning; How To Change Oil And Clean Filter - Serpento CLICK 125T-6 Manual De Usuario

2. Oil change and filter cleaning:

• When to change oil and clean filter.
• Change oil and clean filter at first 300km and every 1000km after.
Capacity of Oil
Disassembly: 0.91iter
General Change: 0.75liter

3. How to change oil and clean filter:

• Remove oil level gauge, Remove drain plug to make all the oil flow out. If engine is warm, it is easier to make oil flow out.
• Remove oil filter cap and take off spring and filter screen. Use high-pressured air to clean.
• Install oil filler and drain plug.
• Fill with new oil 0.9 liter. Check with oil level gauge. (Do, not screw in the gauge when check)
• Tighten up oil level gauge
• After engine becomes warm, stop running for 10-20 seconds. Recheck oil volume.
NOTICE:
• Please use SAE 1OW-30(SIGMA) oil.
• Riding in the following conditions will make oil become inferior and please change it earlier.
1) Always ride on gravel road.
2) Always ride for short distance.
3) Always run with neutral gear.
4) Ride at the area with cold weather.
26