Uninstall Washer And Dryer; If Your Washer Or Dryer Is Still In Its Packaging; Installation Instructions - Whirlpool W10882520 Instrucciones De Instalación

UNINSTALL WASHER AND DRYER

IMPORTANT:
If your washer and dryer are already installed,
they must be uninstalled.
If you need to uninstall your washer or dryer, see the Installation
Instructions that came with your model for tools required.
Uninstalling Your Washer
1. Turn off the water faucet(s).
2. Unplug the power supply cord.
3. Slowly loosen the fill hose(s) at the faucet(s) to relieve the
water pressure. Use a sponge or towel to absorb the released
water.
4. Remove the fill hose(s) from the back of the washer. Drain
water in the hose(s) into a bucket.
5. Remove the drain hose from the wall/floor drain pipe or utility
sink and drain any water in the hose into a bucket.
Uninstalling Your Dryer
1. Disconnect the power supply.
2. Remove the drain hose from the floor drain pipe or utility sink
and drain any water in the hose into a bucket.
IF YOUR WASHER OR DRYER IS STILL
IN ITS PACKAGING
Position the packaged washer or dryer close to its final position.
Cut the packaging as follows:
Washer: Cut plastic film along dotted cut line around the
n
base. Remove the packaging. Do not remove the shipping
bolts.
Dryer: Cut around top and down corners along dotted cut
n
lines. Discard carton top, corner posts and sides. Leave
carton bottom underneath dryer.
4

INSTALLATION INSTRUCTIONS

1.
Move washer
48"
(1.2 m)
It is necessary to remove all shipping materials for proper
operation and to avoid excessive noise from washer.
Move washer to within 48" (1.2 m) of its final location. It must
be in a fully upright position.
IMPORTANT: Keep the feet on the washer even in a stacked
installation.
2.
Ensure washer is level in its final
location
Place level here.
Place a level on top edges of washer,
checking each side and front. If not level, tip washer and
adjust feet up or down as shown in Installation Instructions,
repeating as necessary.
Not Level
LEVEL
Not Level