Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Car audio Wi-Fi A/V mirror interface through HDMI™ or AUX/AV-IN
INTRODUCTION
With this Wi-Fi interface you will be able to mirror your iOS® or Android™ device on your aftermarket in-dash mobile video screen.
Note: This will not allow the mobile device to be operated from the aftermarket in-dash mobile video screen. All operations (button presses) will
need to be executed from the mobile device.
Mirroring capabilities are determined by the smart devices' (phone, tablet, etc.) software and the network provider's permissions given to the
device. Software updates can change the devices ability to mirror certain types of video/audio.
INTERFACE COMPONENTS
• AX-MLINK-AVHD interface • AX-MLINK-AVHD harness
• Wi-Fi antenna (qty. 2)
INTERFACE DESCRIPTION
1. Antenna connector (qty. 2): For connecting the external Wi-Fi
antennas.
2. Micro "B" USB: Optional portable power source (5-volts 1-amp required).
Note: Not recommended for streaming video.
3. HDMI™ port: Output to aftermarket in-dash mobile video screen
(HDMI™ cable sold separately).
AxxessInterfaces.com
4. ACC+CVBS connector:
(a) Power cable connections to ACC/GND.
(b) CVBS cable connections to aftermarket in-dash mobile video screen
AUX/AV-IN (Red, White & Yellow RCA jacks).
(c) YPbPr 3.5mm jack.
(d) USB: For software upgrades only.
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
AX-MLINK-AVHD
I N S TA L L AT I O N I N S T R U C T I O N S
TABLE OF CONTENTS
Connections to be made .......................................2
Linking the AX-MLINK-AVHD ..............................2-3
CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
REV. 1/22/18 INSTAX-MLINK-AVHD

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Axxess AX-MLINK-AVHD

  • Página 1 Mirroring capabilities are determined by the smart devices’ (phone, tablet, etc.) software and the network provider’s permissions given to the device. Software updates can change the devices ability to mirror certain types of video/audio. INTERFACE COMPONENTS • AX-MLINK-AVHD interface • AX-MLINK-AVHD harness • Wi-Fi antenna (qty. 2) INTERFACE DESCRIPTION 1.
  • Página 2: Connections To Be Made

    HDMI™-IN. 1. In the settings menu on the iOS® device under WIFI settings, make sure Wi-Fi is turned on. • Connect the Yellow, Red and White RCA jacks from the AX-MLINK-AVHD, to the AUX/AV-IN. Then search for the device “EasyLinkXXX”.
  • Página 3: Technical Specification

    LINKING THE AX-MLINK-AVHD (CONT) Important notes: WI-FI MIRACAST SUPPORT DEVICES 1. This product does not require a network: iOS® mode, to use AirPlay™ Mirroring, you need the following devices: • The Wi-Fi A/V mirror interface uses a Wi-Fi direct connection and does not require a iPhone 4s or later iOS®...
  • Página 4 AX-MLINK-AVHD I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated.
  • Página 5: Introducción

    Las actualizaciones de software pueden cambiar la capacidad de los dispositivos para reflejar ciertos tipos de video/audio. COMPONENTES DE LA INTERFASE • Interfase AX-MLINK-AVHD • Árnes AX-MLINK-AVHD • Antena Wi-Fi (cant. 2) DESCRIPCIÓN DE LA INTERFASE 1.
  • Página 6: Conexiones Que Se Deben Hacer

    Atención: En iOS 11 Se ha deshabilitado el espejo de pantalla. Sólo se permite la transmisión de medios a través de Airplay. • Conecte un cable HDMI™ (no suministrado), al puerto HDMI™ en el AX-MLINK-AVHD, al iOS® 7 y mas: puerto de HDMI™-IN.
  • Página 7: Dispositivos De Soporte Wi-Fi Miracast

    VINCULACIÓN DE AX-MLINK-AVHD (CONT) Notas importantes: DISPOSITIVOS DE SOPORTE WI-FI MIRACAST 1. Este producto no requiere una red: Modo iOS®, para usar la duplicación de pantalla con AirPlay™, necesita los siguientes dispositivos: • La interfase de duplicación Wi-Fi A/V utiliza una conexión directa Wi-Fi y no requiere iPhone 4s o posterior de una conexión de red en su dispositivo móvil.
  • Página 8: El Conocimiento Es Poder

    AX-MLINK-AVHD I N S T R U C C I O N E S D E I N S TA L AC I Ó N IMPORTANTE Si tiene dificultades con la instalación de este producto, llame a nuestra línea de soporte técnico al 1-800-253-TECH. Antes de hacerlo, revise las instrucciones por segunda vez y asegúrese de...

Tabla de contenido