Replace Battery; Led Operation - Honeywell HVC20A1000/U Manual De Funcionamiento

Operating Manual
Maintenance

Replace Battery

The LED will flash red when the battery needs to be replaced.
1 Remove the cover.
2 Insert a new CR2450 coin cell battery into the slot at the bottom of
the remote. See polarity marking on the remote.
3 The LED will briefly flash green. If it flashes red, battery is not
good.
4 Replace the cover.

LED Operation

The LED function is as follows:
• Flashing Green: when a button is pressed.
• Flashing Red: the battery needs to be replaced.
• Solid Amber: disconnected from the system.
• The LED will be off when the remote is idle.
69-2676EFS—01
2
M33096