Conversion For Lp Or Ng Gas; Converting Appliance For Use With Lp Gas; Replace Injector On (One Ring Flame Or Stacked Burners); Replace Injectors On (Two Rings Flame Burner) - FULGOR F5PGK305S1 Instrucciones De Installación

Converting Appliance for Use with LP Gas

WARNING
Conversion is to be performed by a AUTHORIZED
SERVICER (or other qualified agency) in accordance
with the manufacturer's instructions and all codes and
requirements of the authority having jurisdiction. Failure to
follow instructions could result in serious injury or property
damage.
The qualified agency performing this work assumes
responsibility for this conversion.
WARNING
Before proceeding with the conversion, shut off the gas
supply to the appliance prior to disconnecting the electrical
power
If this appliance should be converted for use with gas LP
(propane or butane), each of the following modification
must be performed:
Gas conversion label (aluminium) to be placed on the back
of the appliance, near the data plate, after conversion has
been carried out;
Replace injector on (one ring flame or stacked
burners)
1. Remove the grates and burner cups.
2. Remove aluminum gas spreader.
3. Loosen injector by turning 9-32" (7 mm) nut driver counter
clockwise.
4. Install the injectors supplied with this appliances in the
appropriate burner. The injectors have small number
stamped on the side, this number codes the orifice
diameter and its correct burner location (see figure on
page 17).
5. Turn clockwise to tighten (tighten to a torque of 15 to 20
inch-lbs).
6. Replace all parts following the reverse order.
7. Save the orifices removed from the appliance for future
use.

6 - Conversion for LP or NG Gas

Replace injectors on (two rings flame burner)

1. Remove the grates and burner cups.
2. Remove aluminium gas spreader.
3. Remove the three screws of simmer gas spreader (1).
4. Remove the two screws of injector cover (2).
5. Loosen injector (A) by turning 9-32" (7 mm) nut driver
counter clockwise.
6. Loosen injector (B) by turning 9-32" (7 mm) box wrench
counter clockwise.
7. Install the injectors supplied with this appliances in the
appropriate burner. The injectors have small number
stamped on the side, this number codes the orifice
diameter and its correct burner location (see figure of
the paragraph "Injectors position").
8. Turn clockwise to tighten (tighten to a torque of 15 to 20
inch-lbs).
9. Replace all parts following the reverse order.
10. Save the injectors removed from the appliances for
future use.
EN
15