Led Display; Main Menu Functions - Hydrofarm Autopilot APCEM2 Manual De Instrucciones

LED DISPLAY

at Plant Mode
at Human Mode

MAIN MENU FUNCTIONS

The Main Menu (8) functions can be toggled through by using MENU. If the main menu is not brought
up, the green bar will remain blank, leaving the UP and DOWN buttons to toggle between parameters
and Zoom Levels, respectively.
Pressing MENU once will bring up the main menu, with an underlining flashing bar indicating the
current choice.
To select the function, press ENTER when it is underlined by the flashing bar. Note that after 1 minute
if nothing is pressed, the Main Menu will disappear and the device will revert to the normal state.
HOLD HOME
To revert to start up settings at any point, hold ENTER for 3 seconds until there's an audible beep. The
device will revert to Home Setting, as if the power was reset, displaying "Back Home done." Note that
this is not the same as Restore to factory settings.
On the next page is a table showing what main menu selection is made by pressing MENU multiple
times as well as their functions. Note that the device will display "Done," followed by the confirmed
selection if selected correctly.
INSTRUCTIONS
ALARM PLANT LOG CALI ALTI 0C/0F ADV
5