Important - Favero Electronics MILLENNIUM REEL Informaciones Técnicas

I M P O R TA N T: W i n d t h e s p r i n g s f o r a
minimum of 9 turns and a maximum of 10
turns. If wound for less than 10 turns, the
spring's life decreases.
P6
- Verify conductivity. Before finishing, use
a tester to verify the proper conductivity
between each bush of the fencer 's end
socket and its correspondent at the bottom of
the reel case. T he electric resistance
between the bushes should be lower than 3
ohm.
P7
- Replace the cover.
from step to replace the cover.
P1
SPRING GROUP REPLACEMENT
CAUTION: Replacement of the springs
should be performed by trained staff.
The springs are under tension and their
release may cause injuries.
Never remove one spring from its bucket
and never overturn a bucket without its
cover.
When a spring breaks,
the entire 3 spring group
This operation is not only easier and faster
than replacing a single spring, but also
avoids possibly breaking the other two worn
springs as each spring has about the same
life.
In order to replace the spring group, these
instructions should be followed in order:
P8
- Remove the cover and release the
spring tension as in instructions
P9
- U nsolder the three wires from the B1
printed circuit board (fig.B) placed at the
center of the reel (see
perfectly the wires.
P10
- U nscrew the three nuts in position
B3(fig.B). Carefully and slowly raise and
remove the coil with the wound cable.
P11
- U nsolder the 3 wires that are soldered
at the E1 spring positions (fig.E).
P12
- Unscrew the 3 nuts at the E2 positions
and remove the spring group. Be careful not
to overturn the spring group so as not to
detach the upper spring.
P13
- Install the new spring group.
Use the 4 screws
you should replace
(article 900-02).
and .
P1 P2
Note2 ). Straighten
The
reference labels should match. Set it with the
three E2 screws (fig.E) and solder the three
E1 wires on the spring external ends.
P14
- U nscrew the 3 nuts placed on the
central plastic pin of the new spring group
and remove the protective cover. Straighten
perfectly the 3 wires that come out from the
spring group central area toward the top.
P15
- Replace the coil with cable over the
spring group.
should enter the 6 central holes. The yellow-
green wire should enter the hole next to the
flat cable. (see B2, fig. B).
P16
- C lamp the 3 B3 nuts (fig.B) and solder
the 3 wires to the printed circuit board.
Finally, follow instructions
Note1:
IMPORTANT: When the springs are under
tension, keep the coil with unwound cable
steady with your hand otherwise the
springs will certainly be damaged.
release of the springs will not be stopped by
the cable end, and the rotation of the coil
causes harmful bending of the springs.
Note2:
When you solder or unsolder wires, make
sure you keep the iron's temperature at abo-
°
ut 330 C. Soldering should last only a few
seconds in order to avoid damage to the
printed circuit board.
For article codes see page 5
7
ENGLISH
The 3 wires and 3 screws
- -
P5 P6 P7
.
Q uick