Mounting On The Wall; Installation In An Existing Extractor Hood - PlasmaMade GUC 1214 Manual Del Usuario

Mounting on the wall

1. With the aid of a spirit level, draw a vertical line above the motor housing.
Above the motor housing, drill the lower hole (in this take account of the
maximum dimension indicated in the drawing) and 90 mm above it, the
second hole (you can use the fixing bracket to position the upper hole).
2. Bend both sides of the fixing bracket round and fix it to the wall using the
plugs and ø 4.2 x 25 mm screws supplied..
3. Slide the PlasmaMade Airfilter on to the mounting bracket.
4. Fit a flexible duct (not supplied) between the motor housing and the
PlasmaMade Airfilter.

Installation in an existing extractor hood

Remove the duct from the existing extractor hood. Mount the PlasmaMade Airfilter
carefully and level on the motor housing or on the wall according to the instructions
above.
12