TOOL DISASSEMBLY
1.
Be sure tool is unloaded! Grasp the
knurled collar and unscrew the
Fastener Guide Assembly. Once
unthreaded, pull it from the tool.
2.
On the Barrel Retention Collar, locate
the raised Line on the side and top of
tool. Turn the Barrel Retention Collar
90 degrees so that the side mark on the
collar Is aligned with the top mark on
the tool. Lift off the Collar.
3.
Grasp the Barrel, then pull open the
two pawls. Note that the pawl assembly
is hinged and is not removed. Use
caution as barrel is under slight
spring pressure.
Remove barrel and spring from tool
4.
body.
5.
Remove the Barrel Spring and Piston
from the Barrel Assembly.
DISASSEMBLY
UNSCREW THE
FASTENER GUIDE
SLIDE BARREL ASSEMBLY
OUT OF THE TOOL BODY
REMOVE THE RETAINING SLEEVE
REMOVE THE RETURN SPRING
DISASSEMBLY
1
2
3
4
5
15