Completing Installation - NuTone HEAT-A-VENTLITE 9093WH Manual De Usuario

WIRING
Installation work and electrical wiring must be done by
a qualified person(s) in accordance with all applicable
codes and standards, including fire-rated construction
codes and standards.
Refer to Figure 2.
1. Run five (5) wires and ground of 12 gauge from heater's
junction box to wall switch.
HEATER
JUNCTION
BOX
T
HEAT
NIGHT
LIGHT
SWITCH BOX
(REAR VIEW)
120vAC
LINE
TO HOUSE
PANEL BOARD
2. The switch installs in a double-gang outlet box. When a
thermostat or timer is used, connect at point marked "T".
3. Replace junction box cover in heater housing when wiring
is complete.

COMPLETING INSTALLATION

Refer to Figure 3.
1. Insert hooked hinge on power unit to hanger bracket in
rough-in housing.
SLOTTED
HANGER BRACKET
HOUSE
WIRING
VENT
LIGHT
HOUSE
WIRING
FIGURE 2
FIGURE 3
2. Swing fan and heater unit into place over mounting bracket
screws and tighten securely.
3. Plug in fan and heater assembly to receptacle in junction
box cover.
NIGHT LIGHT
RECEPTACLE
KEY-HOLE
SLOT
Refer to Figure 4.
4. Install 100 watt bulb and 7 watt lamp for night light.
5. Mount grille and lens assembly over mounting screws in
housing. Tighten securely.
INSTALLATING IN EXISTING
CONSTRUCTION
1. Review "WIRING" section of these instructions.
2. Drill a small hole in ceiling in proposed location (locate
this hole in attic or crawl space).
3. In attic, mark ceiling for cutout by using the housing as
a template. Mark around outside of plaster flange. Make
cutout along this line.
4. Connect wires from switch to heater before mounting
the housing.
5. Install a header between ceiling joists and nail housing to
one joist and header.
NOTE: The two (2) hanger bars (separate pieces) and two
mounting brackets (on the housing) are not needed for this
type of installation.
6. Install ductwork.
7. Install power unit, light bulbs and grille/lens assembly. Refer
to "COMPLETING INSTALLATION".
NOTE: Please refer to your NuTone catalog for a complete
listing of optional accessory items.
MODEL 9093WH
Page 3
LIGHT
RECEPTACLE
KEY-HOLE
SLOT
FIGURE 4