FAAC TMK 28 R Manual De Usuario página 21

8
8.1 HOW TO MEMORY-STORE THE FIRST TRANSMITTER
Portable remote control
Wall-mounted remote control
MAX. 20 RADIO DEVICES CAN BE STORED IN THE MEMORY OF THE MOTOR INTERNAL RECEIVER (WALL-MOUNTED REMOTE CONTROLS,
RADIO ANEMOMETERS, ETC.). MEMORY STORING CAN OCCUR IN ANY MOTOR STATUS.
MOTOR HEAD SIDE
TYPE 1
TYPE 3 TYPE YPE 3
8.1 DELETION OF THE INTERNAL RECEIVER'S MEMORY (RESET)
1. Cut power to the motor.
2. Connect the black or red wire to the brown wire. (If you have the "step-by-step" push-button, just hold it down without making
any connection. Chap.7.2)
3. Power up the motor
4. After approx. 5 seconds, the motor moves in both directions for 1 second, signalling that the memory was completely
deleted
5. Cut power to the motor again
6. Disconnect the black or red and brown wire (Release the push-button if you have the step-by-step push-button. (Chap.7.2)
HOW TO USE THE TRANSMITTERS
UP
STOP /
DOWN
According to the configuration of your installation (Fig.20)
observe the instructions given in the following paragraphs.
TYPE 2
1.
2.
3.
1.
2.
TYPE 4 TYPE
3.
4.
Fig.20
9
TYPE 1 and 4
Supply the motor with power.
Within 15 seconds press the P programming push-button,
then the DOWN push-button of the transmitter.
The motor performs two brief movements in both directions
to confirm the correct programming. Perform some brief
up, stop and down movements to check if the operation
is correct.
TYPE 2 and 3
Supply the motor with power.
Within 15 seconds press the P programming push-button,
then the UP push-button of the transmitter.
The motor performs two brief movements in both directions
to confirm the correct programming
Perform some brief up, stop and down movements to check
if the operation is correct.
PROGRAMMING
PUSH-BUTTON
Fig.19