HORIZON 75998 Instrucciones De Instalación página 6

4. Locate center line of lower fascia and trim the area as shown in Figure 4.
5. Remove (1) rubber square plug from each frame rail. Return it to owner. Detach (3) vehicle wiring plastic fasteners from frame rail both sides, using a screwdriver
or trim panel tool. NOTE: On Trailhawk models remove (2) existing M14 bolts from the rear vertical and horizontal frame on each side. Keep them for reassembly.
Trailhawk
3.5''
3.75''
6. Feed the carriage bolt ① and spacer ② through access square hole using the pull wires ⑧ for both vertical and horizontal slots, as shown in Figure 5. Leave pull
wires attached. NOTE: On Trailhawk models only feed (1) vertical hardware through forward square slot and reuse (2) M14 bolts removed in step 4 each side.
Trailhawk
©2015-2018 Horizon Global™ Corp - Printed in Mexico Sheet 6 of 21 75998NP 10-10-18 Rev. E