PRONAR VMP-5S Manual De Instrucciones página 20

EN
DigiDevice
NOTE: Once the amounts of the components to be loaded are settled, it is possible to go
directly to the loading operation by pressing the
Execution Options
To set the Execution Options of the load and unload
with the and
Go through the below descript menu items with the
show the settings. For settings modifying, change the value with the
confirm with or cancel with
Automatic Components Step
If the parameter is settled ON, the step from a component to the next one during the loading
sequence is automatic, after a component is loaded. If the parameter is off, after a component
is loaded, the
Formula Percentage
If the parameter is settled ON, the function that allows to increase or decrease the amount of
loads and unloads based on the percentage value settled in the Load Program is active. If the
parameter is off, that function is not used and does not appear during load programming.
Weight Options
To define the Weighing operation
keys the menu item
Go through the below descript menu items with the
show the settings. For settings modifying, change the value with the
confirm with or cancel with
Weight Division
By selecting an available value, with the
variation can be defined. Resolutions as a 1, 2, 5 o 10 units can be selected. Confirm the
modification with
Weight Velocity
This parameter defines the refresh velocity of the weight value. Setting a low value means a
longer refresh time and vice versa. Select an available value with the
confirm the modification with
20
keys the menu item
.
key shall be pressed to load the next component.
Options, press the
"weig. Opt". Confirm with the
.
or cancel with
or cancel with
key.
operations, press the
"execut. Opt.". Confirm with the
and
key and select with the
key.
and
and keys, the minimum displayable weight
.
.
key and select
key.
keys and then press
and keys, then
and
keys and then press
and keys, then
and keys, than
to
to