Cooper ASPIRE RF9500 Instrucciones

Instructions for RF9500
ON/OFF
BUTTON
DIMMER
BUTTON
Battery installation and
replacement:
2 CR2025 batteries are included with
each RF9500. Lift the battery latch
with a screwdriver to open the battery
cover. Remove the plastic inserts from
under the battery. Observe polarity
when installing the batteries. Re-latch
the battery cover.
After the batteries are successfully
installed, the LED on the RF9500 will
blink for one minute to indicate the
device in not included in the RF
network. The device will go to sleep
after one minute to conserve battery
life. When not installed, pressing the
ON/OFF button again will wake up
the device, and the LED will
resume blinking for one minute to remind the installer that the device
is still not installed in the RF network.
With normal usage battery life is expected to be 1-2 years.
Programming the RF9500:
The RF9500 must be first installed in the RF network, and then
associated with another hard-wired RF device that is connected to
the load. Through association the RF9500 will wirelessly control these
other hard-wired RF devices, such as a switch, receptacle or dimmer.
One RF9500 can be associated with up to 5 other hard-wired RF
devices at one time.
For detailed programming instructions refer to the ASPIRE RF manual
included with the Handheld (RFHDCSG) or Table Top (RFTDCSG)
controllers.
The RF9500 is included in the RF network by pressing the ON/OFF
switch button during the network installation process.
During the association process, the Cooper Controller will prompt the
user to wake up the RF9500, which will then allow the association
process to occur. To wake the RF9500 press the On/OFF switch once.
Installation instructions:
The RF9500 can be pasted onto any flat surface using double-sided
tape provided.
The RF9500 can be mounted to the wall using 2 screws and anchors
provided. To install the RF9500 beside an already existing installed
wall mounted device, use one RFBS22 inner wallplate for every
existing installed device and the appropriate multi-gang ASPIRE
wallplate (9521, 9522, 9523, 9524, 9525 or 9526).
NOTE: Do not install RF9500 over an electrical box. The device must
be installed onto a flat surface.
Operating instructions:
• The blue LED indicator is normally OFF.
• The blue LED indicator will blink once when turnng a device OFF.
• The blue LED indicator will come on for 2 seconds and then turn
OFF when turning a device ON.
• The ON/OFF switch on the RF9500 will turn the load ON/OFF when
associated with the RF9501 or RF9518 switch or other Z-Wave RF
switches.
ENGLISH
Product Explanation Description:
The RF9500 is a battery-operated device that
allows you to install a switch/dimmer almost
anywhere you desire and control (On/Off/
Dim/Brighten) loads/lights wired to ASPIRE RF
devices using the Association function
(i.e. creating a 3-way where a second
location is not currently available). The RF9500
can then be used to wirelessly control other
hard-wired RF devices such as a switch, dim-
mer, or receptacle. This wireless control is done
by associating the RF9500 with these other
hard-wired devices.
OPEN
Lift Latch to
Open Battery
Cover
™