Mechanical Control Panel; Operation - Omcan BL-CN-0002-B Manual De Instrucciones

Note:
1. Pulse switch is mainly used for testing or blending special materials do not use it frequently.
2. Do not run for more than 2 minutes when blending dry materials.
CONTROL PANEL

MECHANICAL CONTROL PANEL

ON/OFF Switch
Up for ON; Down for OFF.
HIGH/LOW Pulse Switch
Up for High speed at 29000rpm; Down for Low speed at 16000rpm. Pulse button can only be used when the
power switch is ON, The PULSE switch can be used to quickly refresh product in the container by depressing
the switch and holding down as long as needed.
Variable Speed Dial
It allows the user to select continuous variable speeds ranging from 16000rpm to 29000rpm. The PULSE
switch overrides the variable speed dial.
Remark:
1. On all units the built-in thermal sensor keeps track of how hot the motor gets and will automatically
shut down the motor if it is overheating. User should remove the container and wait until the
machine cools down. This takes about 2 minutes.
Special Note: Please check your operation when the motor is overheated. If the machine runs all day or
7

Operation