Troubleshooting; Specifications - Royal Sovereign AFX-908N Manual Del Propietário

TROUBLESHOOTING

Symptom
Inserted paper, but the machine
is not shredding.
Finished shredding, but motor
continues to run.
The machine is plugged in, but
the Power On Indicator is not on. Check to make sure that the Pull Out Bin is pushed in correctly. Check the power switch is turned on.
The Motor Overheat/Overload
Indicator is on, and the shredder
is not running.
The paper starts to automatically
reverse.
The paper is jammed
If you are still having complications, please contact Royal Sovereign's Service Center at 1-800-397-1025. In Canada. (1-866-961-6673)

SPECIFICATIONS

Model
Entry width
Shredder Size
Unit Dimensions (w x d x h)
Power Supply
Power Consumption
Basket Volume
Unit Weight
Manual Feed Capacity
Auto Feed Capacity
Speed
Continuous Run Time
Noise(dB)
Check if unit is plugged in. Check the power switch is turned on. Turn the control switch to AUTO. Check
if there is jammed paper. If paper is jammed, turn the control switch to REVERSE to retrieve jammed
paper. Then turn the switch to STOP and back to AUTO.
Internal sensor may be covered by dust or small pieces of paper. Turn the control switch to REVERSE to
try and move the pieces of paper. Then turn the switch to STOP and back to AUTO.
Too much paper was inserted into the entry at once or the motor is getting hot from over 10 minutes of
continuous use. You will have to wait till the shredder cools down (approximately 30 minutes). The
Indicator will shut off and you can resume shredding.
Too much paper was inserted into the entry. The paper was not inserted neatly and is jamming. After
the paper is reversed, check the quantity of the paper inserted to make sure it meets the suggested
amount. Then arrange the paper so all pieces go straight into the entry.
When using the manual feed entry, gently pull the jammed papers out. Check to make sure the quantity
of paper does not exceed maximum capacity. Turn switch to STOP and back to AUTO. Re-insert paper.
When using auto-feed entry, press and lift the safety cover and gently remove jammed paper. Re-stack
paper neatly, ensuring quantity of paper does not exceed the maximum capacity, and stapled sheets are
inserted with staples at top. Turn switch to STOP and back to AUTO. Re-insert paper making sure non-
stapled side of paper enters feeding entry first. If paper cannot be pulled out from either entry, internal
Jam removal function will automatically activate.
7
Solutions
AFX-908N
8.7 in / 220 mm
2mm x 14mm
13.6 x 9.8 x 23.8(in) / 346 x 248 x 605(mm)
120V 60Hz
250W
5.28 gal / 20 L
22.3lbs / 10.1 (Kg)
7sheets (letter / A4 / 80g/m
75sheets (letter / A4 / 80g/m
9.8 ft/min / 3.0 m/min
10 minutes
55 (dB)
AFX-908N
paper)
2
paper)
2