Tabla de contenido
Publicidad
11.3.2.2 Modbus TCP Settings
Settings → Network Setup Settings → IP Address
Settings → Network Setup Settings → IP Address
Settings → Network Setup Settings → IP Address
VA 520 EN V1.22
→
MB TCP
→
ID
→
Port
For changes, e.g. the sensor ID,
first select by pressing key
then key "OK".
Select the desired position by pressing the
and select with "OK" button.
Change values by pressing the
takeover by pressing
"OK".
Input for the port is done analogue.
By means of the button
possible to change the data format (Word Order).
Possible formats are
"ABCD"
"CDAB"
(Middle Endian)
Saving the changes by pressing
therefore select it with key
it with
"OK".
Reset to the default settings by activating
Default"-
Funcionamiento
„>"
"ID"
the field
and
">"
„>"
values
"Byte Format"
it is
(Little Endian) and
"Save",
„>"
and then confirm
"Set to
pág. 26 de 40
Publicidad
Tabla de contenido
