Initial Setup - Crosley T300A Manual De Instrucciones

English

Initial Setup

Essential Setup
1. Place the unit on a flat and level surface. The selected location should be
stable and free from vibration.
2. Install the turntable lid to the hinges.
3. Remove the tie-wrap that is holding the tonearm.
4. Place the slip mat on top of the turntable platter.
5. Connect AC adaptor to the Power Jack of the unit.
Note: Do not plug the AC power adaptor to power outlet before all the assembly is
completed. Before turning the power on, make sure again all the connection settings
are correct. Always turn off the power when connecting or disconnecting.
Drive Belt Assembly
The belt and turntable platter have been installed properly at the factory, if the
belt is loose during transportation, you can fix it by following below instructions.
1. Remove the slip mat from the turntable platter. Remove the E clip from the
turntable spindle and then remove the turntable platter.
2. Place the belt around the outside wall of the turntable platter's drive rim and
make certain that the belt is smooth and flat all the way around.
3. Put the turntable platter back on the spindle, make certain it is fully seated,
and align one of its openings over the brass motor pulley position.
4. Through the opening, carefully hook the turntable belt with a drive belt
assembly tool (not provided) or a finger and put the belt over the brass motor
pulley. Make sure the belt is not twisted between the pulley and the platter's
drive rim.
Note:

Do not use a sharp object to perform the above step.

Make sure hands are clean while performing this job. Avoid oil or grease over the
belt.
5. Put the E clip back over the spindle and place the slip mat on the platter.
Auto Return Mechanism Reset
The auto return mechanism inside the turntable might have parts shifted during
transportation which can cause malfunction of the auto return mechanism.
Always reset the auto return mechanism after the turntable is moved.
1. Use the cue lever to lift up the Tonearm.
2. Gently hold and move the Tonearm towards the Turntable Spindle
until the Tonearm starts to pull back.
3. Release the Tonearm and it will return to the Tonearm Rest
automatically. Now the mechanism is reset properly.
5