Technical Features; Troubleshooting - Super Ego AIR 300 Manual Del Usuario

Technical features

Voltage: 12 V / 10 A.
Pressure: 300 psi /18 bar.
Dimensions (LxWxH): 12.5 x 14 x 6 cm.
Weight: 700 g
Recommendations
1. Do not keep the compressor running for more
than 7 minutes at a time. If a longer time
is needed, switch it off and let it rest for 10
minutes before switching it on again.
2. This compressor is not designed to inflate high
pressure tyres of the type used in lorries, trailers
or tractors.
3. Do not keep it running for more than 7 minutes
when used at more than 75 psi/ 5 bar.
4. When in use, never leave the compressor
unattended
Tyre inflating instructions
1. Move the vehicle until the tyre valve reaches
the lower position, as close to the ground as
possible.
2. Switch the plug
3. Place the clip-on valve connector
tyre valve, press it fully and close the safety
lever 5.2 .
4. Switch on the compressor
5. Once the desired pressure has been reached,
switch off the compressor
6. Release the safety lever
adaptor from the tyre valve and remove the
plug 3 from the car lighter socket.
7. When putting away the device, make sure to
leave the valve connector safety lever
open position.
Trouble shooting
Problem
1. Press firmly the plug into the car lighter socket and turn it in both directions.
The compressor
2. Check for dirt in the vehicle and the sockets, specially if tobacco is present. Use non
would not
start / no air
3. Check the lighter fuses. They must be 15 A as a minimum.
released
4. Check that the device is not switched off.
The compressor 1. Make sure the connector is well pressed on the valve before closing the safety lever.
starts but does 2. Check the object for air leaks.
not inflate 3. Check the air hose for tears and leaks
The compressor 1. Overheating due to excessive use. Switch it off and let it rest for 30 minutes.
is running slow 2. Check the battery status. Too low voltage
3 into the car lighter socket.
5
2 (I position).
2 (O position).
5.1 , remove the
conductive material for cleaning. Do not use your fingers or any type of metal.
Use of adaptors
1. Choose the right adaptor
it into the connector
safety lever
2. Review the instructions manual to find product's
adequate pressure. For instance: Football (13
psi), inflatable dinghy (firm).
3. Insert the adaptor into the object to be inflated.
4. Connect plug
5. Switch on the compressor
6. Once the adequate pressure has been reached
switch off the compressor
remove it from the car lighter socket
7. Remove the adaptor from the inflated object.
Remove the adaptor
connector. Remember to leave the valve
connector safety lever
8. Always make sure the object is inflated at the
right pressure.
Caution
on the
Objects with excessive inflation pressure might
explode and cause severe damage.
This compressor may operate at 300 psi. Thoroughly
follow the instructions to prevent excessive inflation
pressure. Never exceed the recommended pressure.
Do not leave the device unattended when in use.
Keep the compressor away from the children.
Make sure the inflator is firmly screwed to the tyre
valve.
5.1
in
Solution
ENGLISH
7
5 . Close the inflator
5.2 .
3 into car lighter socket.
2
2
7
5.1
open when not in use.
Using very high pressure for low pressure
objects must be prevented.
Avoid excessive inflation pressure. Never
exceed the recommended
8
or and insert
(I position).
(O position) and
3 .
8
or from the
pressure.
5