Installation To Wood Stud Wall - peerless-AV PA740 Instalación Y Ensamblaje

Installation to Wood Stud Wall

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is fi rmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs.
Installers are responsible to provide hardware for other types of mounting situations (not evaluated by UL).
Using a stud fi nder, locate and mark the edges of the wood stud used in mounting this product. Use of an edge to
2
edge stud fi nder is highly recommended. Use a level to draw a vertical line down the center of the stud. Use wall
plate as template to mark center of holes along the vertical line. Drill two 5/32" (4 mm) dia. holes 2.5" (64 mm)
deep. Attach wall mount (A) to wall using two #14 x 2.5" fl at head wood screws (C) as shown.
Skip to step 3.
A
WARNING
WALL PLATE
C
5 of 46
ISSUED: 01-27-08 SHEET #: 095-9283-8 01-25-12
WOOD
STUD